Pool Shock Calculator

The right shock level for your stabilizer reading, and how much of your product it takes.

Why are you shocking?
Pool volume (work it out)

Unstabilized shock (liquid chlorine, bleach or cal hypo) is the best choice for most pools. "Shock" bags are usually cal hypo or dichlor; the label tells you which.

Shock dose

Fill in the boxes and your answer appears here.

How to use it

  1. Pick the reason. Routine shocking, a chlorine smell and algae each need a different chlorine level.
  2. Enter free chlorine and stabilizer (CYA) from a fresh test. For the chlorine-smell option, also enter combined chlorine.
  3. Choose your product. The result shows the dose, how to add it, and what it does to stabilizer and calcium.

Shock level depends on stabilizer

A bag that says "one pound per 10,000 gallons" assumes a pool with little or no stabilizer. Stabilizer holds most chlorine in a slow-acting form, so a pool at 60 ppm CYA needs far more chlorine to reach the same killing power as one at 20 ppm. For algae, the level used widely in residential pool care is about 40% of the CYA reading, with 10 ppm as the floor. At 40 ppm CYA that is 16 ppm; at 80 ppm it is 32 ppm.

This is also why shocking with dichlor or trichlor backfires. Each ppm of chlorine from dichlor adds 0.9 ppm of stabilizer. A 15 ppm dichlor shock adds about 14 ppm of CYA, which raises the next shock level by another 5 or 6 ppm, and the cycle continues until the pool needs draining.

Worked example

Green-tinged 20,000-gallon pool, FC 1 ppm, CYA 50 ppm, 12.5% liquid chlorine.

Shock level for algae = 40% × 50 = 20 ppm. The rise needed is 19 ppm. 20,000 gallons is 75,710 liters, so the pool needs 19 × 75,710 ÷ 1,000 = 1,438 g of chlorine. Fresh 12.5% liquid chlorine holds about 142 g per liter, so the first dose is about 10.1 liters: 2.7 gallons. After that, the job is holding 20 ppm with smaller top-ups until the water clears.

How it's calculated

  • Routine shock: 10 ppm, or 25% of stabilizer if that is higher. Product labels call for 5 to 10 ppm when superchlorinating; the stabilizer adjustment keeps that meaningful in a stabilized pool.
  • Chlorine smell: the smell comes from combined chlorine (chloramines), not from too much chlorine. Breaking them down takes free chlorine of roughly 10 times the combined chlorine reading, added on top of what is already there. We never go below the routine level.
  • Algae: 40% of stabilizer, at least 10 ppm, held until the water is clear, combined chlorine is 0.5 ppm or less, and the overnight loss is 1 ppm or less.

The dose itself uses the same chlorine math as the chlorine calculator. Sources are listed on How we calculate.

Mistakes that waste shock

Shocking at noon. Sunlight destroys chlorine fast. Shock at dusk and run the pump overnight.

One dose for algae. Algae uses up chlorine as it dies. A single big dose falls below the kill level within hours, and the algae grows back. Hold the level instead.

Ignoring pH. At pH 8.0, chlorine works noticeably slower than at 7.4. Bring pH down first, with at least 30 minutes between the acid and the chlorine.

Questions people ask

How much shock do I need for my pool?

It depends on why you are shocking and how much stabilizer is in the water. A routine shock is about 10 ppm. Algae needs about 40% of your CYA reading, so 16 ppm at 40 ppm CYA. For a 15,000-gallon pool, 10 ppm takes about 1.4 gallons of fresh 10% liquid chlorine or about 1.9 lb of 65% cal hypo.

Can you put too much shock in a pool?

Yes. Very high chlorine can bleach vinyl liners and swimsuits and irritate skin and eyes, and it stops you swimming until it drops. Using stabilized shock repeatedly is the more common harm, because the stabilizer it adds never breaks down.

How long after shocking can I swim?

Not until chlorine has dropped back to the level the product label allows, which for many labels is 4 ppm or lower. Retest before swimming. After an algae treatment that can take a day or more.

Should I shock the pool at night or during the day?

At night, or at least at dusk. Sunlight breaks down chlorine, so a daytime shock loses much of its strength within a few hours.

Why does my pool smell of chlorine?

A strong chlorine smell usually means combined chlorine, the leftovers of chlorine reacting with sweat and urine. The fix is more free chlorine, not less: shock to break them down.

Estimates only. Product strengths vary from jug to jug and lose strength with age, so treat every amount here as a starting point. Follow the product label, add in stages, and retest before swimming. For stubborn algae, equipment faults or surface damage, call a pool professional. Full disclaimer.

Embed this calculator

Pool service companies and bloggers are welcome to put this calculator on their own site. Copy the code below. Please keep the credit line under it.

My Pool

Saved in this browser only. Nothing is sent to us. Every calculator fills itself in from here.