Pool Opening Plan

A checklist for taking the cover off, then a chemical plan and shopping list from your first test of the season.

Type of pool
Winter cover
Water under the cover
Pool volume (work it out)
Test results after 24 hours of running
Products you use (filled from My Pool)

Your opening plan

Fill in the boxes and your answer appears here.

How to use it

  1. Choose your pool type, cover and how the water looks when the cover comes off. You get the opening checklist straight away.
  2. Open the pool, run the pump for 24 hours, then test the water.
  3. Enter your results. The plan lists what to add, in order, with amounts for your pool, plus a shopping list.

Don't buy chemicals before you test

Opening kits are sized for an average pool and an average winter. Yours may need twice the shock and none of the clarifier. After a winter, the usual picture is low chlorine, alkalinity and pH drifted somewhere, and stabilizer lower than last fall because rain and splash-out diluted it. The only way to know is a test after the water has circulated for a day. Buy what the test says.

Last year's liquid chlorine is the one thing to throw out rather than use. Sodium hypochlorite breaks down in storage, faster when warm, and a jug kept through winter may hold well under half its labeled strength. Dry chemicals such as baking soda, soda ash and stabilizer keep if they stayed dry.

Why shock at opening

Over winter, leaves, pollen and runoff leave organic matter in the water and chlorine runs out. A shock to 10 ppm, or a quarter of your stabilizer reading if that is higher, burns through it and gives the season a clean start. If the water is green, that becomes a proper algae treatment, held for days rather than a single dose.

Worked example

A 20,000-gallon plaster pool, liquid chlorine, clear water. After 24 hours: chlorine 0, pH 7.8, alkalinity 70, calcium 260, stabilizer 25.

The plan adds baking soda to bring alkalinity up (allowing for the acid that follows), then acid to bring pH to 7.5, then a 10 ppm opening shock of liquid chlorine at dusk, and finally stabilizer to bring 25 up to 40 ppm. The shopping list totals the baking soda, acid, liquid chlorine and stabilizer for those steps.

How it's calculated

The order and amounts come from the same planner as our pool chemical calculator: alkalinity, then pH, then chlorine, then calcium, stabilizer and salt, each worked out for your volume and products. The opening shock uses the routine shock level from our shock calculator. Details: How we calculate.

Questions people ask

What chemicals do I need to open my pool?

Usually chlorine for shocking, something to adjust alkalinity and pH (baking soda, acid or soda ash) and fresh test reagents. Stabilizer, calcium chloride and salt only if your test shows they are low. Test first and buy what the test says.

What order do I add chemicals when opening a pool?

Run the pump 24 hours and test. Then alkalinity, pH, shock (at dusk), calcium, stabilizer and salt. Add one at a time with the pump running.

How long after opening can I swim?

Once the water is clear, the chemistry is in range and chlorine has dropped back to the level your product label allows after the shock. Often that is two or three days.

Should I shock my pool when opening it?

Yes. A shock to about 10 ppm, higher with a lot of stabilizer, clears out what built up over winter. If the water is green, treat it as algae and hold the level until it clears.

Estimates only. Product strengths vary from jug to jug and lose strength with age, so treat every amount here as a starting point. Follow the product label, add in stages, and retest before swimming. For stubborn algae, equipment faults or surface damage, call a pool professional. Full disclaimer.

Embed this calculator

Pool service companies and bloggers are welcome to put this calculator on their own site. Copy the code below. Please keep the credit line under it.

My Pool

Saved in this browser only. Nothing is sent to us. Every calculator fills itself in from here.