How to use it
- Enter pH, total alkalinity, calcium hardness and the water temperature. These four do almost all the work.
- Add stabilizer if your pool has it. Part of the alkalinity test reading comes from stabilizer, and the calculator removes that share.
- Leave dissolved solids at 1,000 unless you know better. For salt water pools, use your salt reading plus about 1,000.
- Read the verdict. If the water leans one way, the calculator shows which single change would bring it back to zero.
What the number means
Water always tries to reach a balance with calcium carbonate, the mineral in plaster, grout and scale. The saturation index (often called LSI, after Wilfred Langelier, who worked it out in 1936) tells you which way it is leaning. Zero means it is satisfied. Below zero, the water is hungry for calcium and takes it from the walls. Above zero, it has too much and deposits it as scale.
Pool professionals treat −0.3 to +0.3 as balanced and act beyond ±0.5. Temperature matters more than people expect. The index drops by about 0.2 between 85°F and 60°F, so water that sits at the low edge of balanced in summer reads corrosive in a cold spring. And water that balances in the pool can scale inside a heater, where it is much hotter.
Worked example
pH 7.2, alkalinity 70, calcium 150, 70°F, no stabilizer. The index is about −0.7: corrosive. Raising pH alone to about 7.9 would fix it, but that is above the comfort range. Raising calcium alone would take it past 700 ppm. The sensible fix is a bit of each: alkalinity to 90 with baking soda, which also lifts pH, then calcium toward 250.
pH 7.8, alkalinity 120, calcium 400, 84°F, stabilizer 50. About +0.6: scale-forming. Bringing pH down to about 7.2 brings it back to zero, and lowering alkalinity keeps pH from climbing again.
How it's calculated
LSI = pH − pHs, where pHs is the pH at which this water would be exactly saturated with calcium carbonate. pHs comes from the calcium, the carbonate alkalinity and the temperature, using the carbonic acid and calcite equilibrium constants published by Plummer and Busenberg, with activity corrections from the dissolved solids. Carbonate alkalinity is your total alkalinity minus the share contributed by stabilizer and borates at your pH.
Many pool charts use rounded lookup factors for temperature and a fixed correction for stabilizer. We calculate them directly. In our checks against the test-kit manufacturer's own calculator, results agreed to within a few hundredths, and the corrosive/balanced/scaling verdict matched in every case. Details: How we calculate.
Questions people ask
What is a good LSI for a pool?
Between −0.3 and +0.3. Many plaster pool builders aim slightly positive, around 0 to +0.3, to protect new plaster.
Is a negative LSI bad?
Slightly negative (to −0.3) is fine. Below −0.3 the water slowly dissolves plaster and grout and corrodes metal parts; below −0.5 the damage can be visible within weeks.
How do I raise my LSI?
Raise pH, alkalinity or calcium. pH is the quickest; calcium is the most lasting. In a plaster pool with low calcium, raising calcium is usually the right long-term fix.
How do I lower my LSI?
Lower pH with acid first, then bring alkalinity down if it keeps pushing pH up. High calcium only comes down by replacing water.
Why do LSI calculators give different answers?
They use different temperature factors and stabilizer corrections. Differences of 0.1 are common and rarely change what you should do. Ours calculates both from published equilibrium data rather than rounded tables.
Estimates only. Product strengths vary from jug to jug and lose strength with age, so treat every amount here as a starting point. Follow the product label, add in stages, and retest before swimming. For stubborn algae, equipment faults or surface damage, call a pool professional. Full disclaimer.